How To: Pulse your Mini

[Ghillie_55]

I used to rock a mini and I had a hard time figuring out at first how the rf chip for my pulse was hooked up/ used. Anything hopper that uses RF can use this.

So here is what Ive found.

Tadao Technologies - Electronic Boards and Upgrades for Paintball Guns

I went to the above link and bought the Tadao Technologies plug and play harness for the Rf transmitter. The harness is capable of being used on the Intimidator/Marq/AKA/Quest/Mini.

http://i241.photobucket.com/albums/ff168/jake_ekaj_55/MIni/DSC00515.jpg

I was amazed at how easy the trasaction went and how fast they shipped. For the 15 dollar shipped price, IMO it was well worth it! I purchased the harness on a Saturday and recieved it on Wednesday.

So here is how to install the harness:

Step one, take the upper body off the grip frame by removing the two body frame screws.

http://i241.photobucket.com/albums/ff168/jake_ekaj_55/MIni/DSC00516.jpg

Next, unplug the solenoid and plug in the harness. Orange and yellow solenoid wires go to red and black wires. Rf chip plugs into white wires.

http://i241.photobucket.com/albums/ff168/jake_ekaj_55/MIni/DSC00517.jpg

Now, gently slide upper body and wires back into grip frame. Make sure that no wire are getting caught or snagged on the sides of the frame. Now there should be enough room in the grip for harness and chip to rest peacefully.

http://i241.photobucket.com/albums/ff168/jake_ekaj_55/MIni/DSC00518.jpg

Now put grips back on and you have pulsed out mini. (Even though grips really dont need to be remove if your good )